Specification:
Model: BMS 60A 3S 12.6V Enhanced Version
Charging Voltage: 12.6-13.6V
Continuous Discharge: 60A
Continuous Charging: 10A
Enhanced version: Suitable for starting current below 120A, power below 260W electric drill.

Note 1: Successfully starting the drill requires 3 10C-20C power batteries, or 6 5C-10C power batteries (recommended power battery models :SONY VTC4, VTC4A, VTC5A, VTC6), 0V and 12.6V connection wires, using copper wires above 4 square mm (no nickel sheets!!). .

Note 2: Successfully starting a motorcycle requires a higher battery! Six 15C-20C power batteries are required, or 12 10C-15C power batteries (recommended power battery models :SONY VTC4, VTC4A, VTC5A, VTC6), and the motorcycle needs to have a charging voltage regulator circuit.

Note 3: Wire 0V, 4.2V, 8.4V, 12.6V strictly according to the diagram, do not touch any components on the board when welding wire, do not intentionally short circuit.

Note 4: When welding the battery for the first time or charging, as long as the single battery exceeds 4.2V, the "430" resistor will heat for discharge (discharge to 4.19V or so to stop heating). If the "430" resistance is seriously hot (hot hands do not dare to touch), check whether the wrong wire is connected.

Package Contains:
1Nos BMS 60A 3S 12.6V